Shandong Yushen Energy Technology Co., Ltd.
Shandong Yushen Energy Technology Co., Ltd.
Add to Cart
ASHP Indoor Air Source Heat Pump / Central Heating And Air Conditioning 70A
Air Source Heat Pump Applications
Central Air Source Heat Pump Brief introduction
1. In the central station,several units could be connected in parallel and become central station with automatic control center,providing air conditioning for several buildings.
2. Indoor , it could be connected with users' temperature control facilities, allowing users to implement stratification, household, compartment control, so that heat loss is minimized, and ultimately save energy..
Air Source Heat Pump Features
1. Energy-saving: air source heat pump uses the principle of air energy, only a small amount of electrical energy can be driven. By the low-grade heat energy in the air, the heat exchange is performed through the compressor to provide heating, air conditioning or hot water for the end. A piece of electricity can produce three parts of heat, which is very environmentally friendly and very energy efficient.
2, Total coverage: air source heat pump is an ideal choice for commercial housing, villa buildings, commercial places, users install air source heat pump, can cover all corners without dead angle, but also can provide cold air to the kitchen, provide heating for the toilet, to achieve comprehensive Energy consumption, energy saving and environmental protection.
Air Source Heat Pump Parameter
| Model | SDNA-090YBcode name.pdf | |||
| Compressor capacity | 30HP | |||
| Function | Heat | |||
| Electricity | 380V 3N-50Hz | |||
| Working conditions | ℃ | -25~+45 | ||
| Data | Heata | Nominal capacity | KW | 56.2 |
| Input power | KW | 23.4 | ||
| COP | / | 2.4 | ||
| Heating IPLV(H) | 2.7 | |||
| A7W35c | KW/COP | 90.0/4.2 | ||
| A2W35 | KW/COP | 79.0/3.20 | ||
| A-7W35 | KW/COP | 63.2/3.0 | ||
| A-15W55 | KW/COP | 56.2/1.97 | ||
| A-20W45 | KW/COP | 47.2/2.04 | ||
| Max. running currency | A | 70 | ||
| Compressor quantity | set | 4 | ||
| Refrigerant/charging quantity kg | / | R22/5*4 | ||
| Air blow type | / | Top | ||
| Water pipe diameter | mm | 50 | ||
| Rating flow | m³/h | 12.6 | ||
| Water side pressure loss | kPa | ≤45 | ||
| Noise level | dB(A) | 62 | ||
| Overall dimensions(L×W×H) | mm | 2100×1100×2080 | ||
| Weight | kg | 830 | ||
QC
Every process must be strictly operated and inspected by our quality persons.
Some main points as below:
1. Check all parts before assembling.
2. Charge nitrogen to test leakage and pressure maintaining after welding system.